Definitive Technology ProSub 60 Manuel du propriétaire télécharger pdf (Page 7)

To hook up your ProSub 60 subwoofer via the high level connections,

simply run speaker cable from the right channel high level connector on

the subwoofer to the right channel speaker connector of your receiver or

ampliﬁer. Repeat this process for the left channel. Please take care that

the red (“+”) terminal on the subwoofer is connected to the red (“+”)

terminal on your receiver or ampliﬁer, and that the black (“-”) terminal

on your receiver or ampliﬁer is connected to the black (“-”) terminal on

the subwoofer. This will ensure absolute phase throughout your system.

Your main speakers can now be connected in one of two ways. If you

wish to utilize the high pass ﬁlter built into your subwoofer, simply

connect your main speakers to the high level out terminals on the

subwoofer. Again, take care to make red to red (“+”) and black to black

(“-”) terminal connections. This connection will provide a smoothly

contoured roll-off of the low frequencies going to your main speakers

starting at approximately 60 Hz. We recommend this hook-up (wiring

the main speakers through the crossover in the subwoofer) when using

ProMonitors. For more overall bass output when using full range main

speakers, run the main speakers full range by hooking them up directly

AMPLIFIER OR RECEIVER

L R

*NOTE: If you

wish to run your

main speakers

full range with

no low frequency

roll-off, hook

them directly to

the main speaker

output terminals

or your receiver

or ampliﬁer as in

any normal hi-fi

system.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Definitive Technology ProSub 60 Manuel du propriétaire Page 7