Definitive Technology ProCinema 400 System Manuel du propriétaire Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 13
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
current going to it, it will reactivate itself with a pop when
AC
current is
restored, which is normal.
Please note that after the cessation
of
a signal, it may take up to an hour
for the amplifier to actually
tum
offfrom active to staildby mode. In some
instances, because
of
RF
presence in your area, the red LEDs may not tum
off. However, this is nothing to be concerned about as the amplifiers draw
almost no power when they are idling.
Using the
ProSub
with
Definitive ProMonitors
When using the ProSub with Definitive ProMonitors, please consult
your ProMonitor instruction manual for specific information regarding
hookup, wiring and placement.
Setting
the
Level and Crossover Frequency When Using
the
ProSub
with
ProMonitors .
When you have the ProMonitors wired to the speaker level outputs
on your ProSub, the following are our suggestions for starting settings on
your controls. Remember, these
ar~
just approximate settings and we suggest
experimenting
to
determine the best-sounding settings for your particular
set-up.
1. Set the variable low pass crossover control on
the back
of
the ProSub to approximately 2
0'
clock. Please note that the exact frequency
will depend on many factors including specific
positions
of
the speakers in the room, so you
might experiment with a slightly higher or
lower setting to achieve ideal blending
between the sub and the satellites for your
particular set-up. Listen to a wide variety
of
music to determine the correct setting for this
in your system.
2. Set the subwoofer level control to 12
0'
clock.
Please note that the exact level depends on
many factors including your room size,
position
of
the speakers, etc. as well as
your personal listening taste, so you might
experiment with the subwoofer level while
listening to a wide variety
of
music until you
achieve the ideal setting for your system.
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire